Spec Driven - Lines & Symbols

This chapter describes the setup in the Wizard if you want to link your P&ID Line Groups, Line Segment, Inline Assets, and Inline Instruments.

Before starting the Wizard make sure that you already setup a Pipe Spec and made the necessary changes to P&ID Properties, 3D Properties, P&ID Classes & Symbols.

Remark: As mentioned earlier we use the term Assign Catalog Data, but it should actually be Assign Pipe Spec Data, because PlantSpecDriven assigns data from the pipe specs and not the pipe catalogs.

Table of Content:

• Page 1 - Link Type

• Page 2 - Pipe Spec Template

• Page 3 - Class Selection P&ID

• Page 4 - Pipe Spec Table

• Page 5 - Linked Fields

• Page 6 - Mapped Fields

• Page 7 - Mapped Ports

• Page 8 - Column Order

• Page 9 - Thumbnail Images

• Page 10 - Miscellaneous Settings

• Page 11 - Special Symbols

• Page 12 - Assign Catalog - Port Properties

• Page 13 - AutoPipe - Flanges

• Page 14 - AutoPipe - Fasteners

• Page 15 - P&ID <--> 3D Mapping

• Page 16 - AttributeFlow

• Page 17 - Link Configuration Name

• Check